Installing the Front Roller (continued)
3. Secure one of the height-of-cut arms to the side plate with a plow bolt,
height-of-cut washer and lock nut. The tab on the height-of-cut washer
should be oriented downward and fit into the slot of the height-of-cut arm.
4. Slide the front roller shaft into the height-of-cut arm attached to the cutting
unit.
5. Slide the remaining height-of-cut arm onto the other end of roller shaft.
Secure the remaining height-of-cut arm to the side plate with a plow bolt,
height-of-cut washer and lock nut.
6. Center the front roller in the cutting unit and tighten the pinch bolts that
secure the front roller shaft to the height-of-cut arms.
7. Adjust the cutting unit height-of-cut; refer to the
Cutting Unit Operator’s
Manual
.
Removing the Rear Roller
g285301
Figure 164
1.
Rear roller assembly
4.
Spacer
2.
Flange nut (2 each)
5.
Shaft retainer
3.
Shim
6.
Socket head screw (2 each)
Refer to
for this procedure.
1. Remove the cutting unit from the machine and place it on a level work surface.
Place blocks under the bedbar to raise the rear roller off of the work surface.
DPA Cutting Units: Service and Repairs
Page 7–24
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev B
