Toro Greensmaster eFlex 2120 04046, Operator'S Manual

Page: 29 / 48

Settings Menu
Menu Item Description
Language Use this setting to change the language used
on the InfoCenter.
Units Use this setting to change the units used
by the InfoCenter. The menu choices are
English and metric.
LCD Backlight Use this setting to increase or decrease the
brightness of the LCD display.
LCD Contrast Use this setting to change the contrast
between the dark and light areas of the LCD
display.
Note:
If you inadvertently change the language
or contrast to a setting where you can no longer
understand or view the display, contact your
authorized Toro distributor for assistance in resetting
the display.
Operating Tips
Important:
Grass clippings act as a lubricant
when mowing. Operating the cutting unit
excessively without grass clippings can damage
the cutting unit.
Preparing to Mow
Ensure that the machine is carefully adjusted and
is set evenly on both sides of the reel. For the best
performance and battery life, set the bedknife to
have a light contact with the reel. Improper mower
adjustment is magnified in the appearance of the
clipped turf.
If the transport wheels are installed on your machine,
perform the following steps to remove the wheels:
1. Push the kickstand down with your foot and pull
up on the handle support until the kickstand has
rotated forward, over center.
2. Remove the transport wheels.
3. Carefully lower the machine off the kickstand.
Mowing the Green
The green should be mowed in a straight
back-and-forth direction across the green. Avoid
circular mowing or turning the mower on the green, as
scuffing may occur.
Turning the mower should be done off the green by
raising the cutting reel (pushing the handle down) and
turning on the traction drum. If you enable the EZ-Turn
switch, the traction unit slows down when you raise
the cutting unit making the turn more manageable,
especially for novice users.
Mowing should be done at a normal walking pace.
Fast speeds save very little time and result in an
inferior mowing job.
To assist in maintaining a straight line across the
green and to keep the machine an equal distance
from the edge of the previous cut, use the alignment
stripes on the grass basket (
Figure 37 ).
g017296
Figure 37
1. Alignment stripes
Operating the Machine in Low
Light Conditions
When operating in low light conditions, use the LED
Light Kit; contact your authorized Toro distributor.
Important:
Do not use other light systems with
this machine; they may damage the battery pack
or electrical system.
Operating the Controls while
Mowing
1. Start the engine, set the throttle to a reduced
speed, push down on the handle to raise the
cutting unit, press the operator-presence control,
move the traction and reel-drive engagement
lever to the F
ORWARD
(transport) position, and
transport the machine onto the collar of the
green (
Figure 38 ).
2. Move the lever to the N
EUTRAL
position ( Figure
38 ).
29