Toro Greensmaster eFlex 1800, Service Manual

Page: 99 / 312

Removing the Transmission
g203645
Figure 57
1. Telescoping coupler 2. Cutting unit hex shaft
1. Park the machine on a level surface, turn the key switch to the O
FF
position,
and remove the key from the key switch. Disconnect the battery pack; refer
to
Connecting the Lithium Battery Pack (page 4–3) .
2. Disconnect the reel clutch cable from the transmission; refer to Replacing
the Reel Clutch Cable (page 6–10) .
3. Slide the telescoping coupler off the cutting unit hex shaft ( Figure 57 ).
4. Remove the right drum drive cover and drive belt from the machine; refer to
Drum Drive Belt (page 4–21) .
5. Remove the electric motor from the machine; refer to Electric Motor (page
5–69) .
6. Remove the battery pack from the machine; refer to Removing the Lithium
Battery Pack (page 5–74) .
7. Remove the 4 washer-head screws (item 8 in Figure 56 ) that secure the
extension housing to the right drum housing.
8. Support the transmission to prevent it from falling.
9. Remove the fasteners that secure the transmission to the machine frame.
A. The flange-head screw (item 2 in Figure 56 ) that secures front of the
transmission to the frame.
B. The bolt (item 13 in Figure 56 ), hardened washer, and flange-head screw
that secure the rear of the transmission to the frame.
10. Carefully move the transmission assembly toward left side of the machine
until the extension housing is clear of right drum housing. Lift the transmission
from the machine.
11. To disassemble the transmission, refer to Transmission Drive Belt (page
4–38) , Transmission Idler System (page 4–41) , Transmission Reel Drive
System (page 4–43) , Transmission Drive System (page 4–50) , and
Transmission Drum Drive System (page 4–53) .
Greensmaster ® eFlex 1800, 2100 and 2120 Page 4–57 Traction and Reel Drive System: Service and Repairs
12189SL Rev E