Toro Greensmaster 3250-D 04383, Service Manual, Page: 237 / 308

Greensmaster 3250−D
SPA and 4−Bolt Cutting Units (Rev. A)
Page 7 − 37
Front Roller Brush/Scraper Removal and Installation
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Loosen and remove cap screws securing each end
of the roller shaft to the front roller brackets.
3. Remove capscrews and locknuts securing the left
front roller bracket to the side plate.
4. Remove front roller from both roller brackets
5. Slide clamp block off each end of the roller shaft.
Note: If the front roller brush/scraper is not to be rein-
stalled, proceed to steps 6 and 7.
6. Reinstall roller to cutting unit with left front roller
bracket and fasteners previously removed.
7. Level front roller and set Height−of−Cut (see Adjust
and Level Front Roller to Reel, and Adjust Height−of−
Cut).
Installation
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Loosen caps crews securing each end of the roller
shaft to the front roller brackets.
3. Remove cap screws and locknuts securing the left
front roller bracket to the side plate.
4. Slide clamp block onto each end of the roller shaft.
Position clamp blocks on roller shaft so the slot is up and
the threaded portion of hole is toward the rear.
5. Thread nut onto each scraper rod.
6. Insert both scraper rods through each clamp block.
Loosely secure scraper rods to clamp blocks with a nut.
1. Front roller bracket
2. Front
roller
3. Clamp block
4. Scraper rod
5. Socket head screw
6. Jam
nut
Figure 62
5
4
1
6
3
2
7. Partially thread a socket head screw into the front of
each clamp block.
Note: Brush/scraper must be positioned with the
scraper to the rear of roller and with the brush down-
ward.
8. Reinstall roller and brush/scraper to the cutting unit
with the front roller bracket and fasteners previously re-
moved.
9. Level front roller and set Height−of−Cut. Refer to
Cutting Unit Operator’s Manual for adjustment proce-
dures.
10. Adjust brush/scraper (see Adjust Front Roller
Brush/Scraper).
SP
A and 4−Bolt Cutting Units