Toro Greensmaster 3250-D 04383, Service Manual

Page: 216 / 308

Greensmaster 3250−D
SPA and 4−Bolt Cutting Units (Rev. A)
Page 7 − 16
Adjust Front Roller Brush/Scraper
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Loosen socket head screws securing the clamp
blocks to the roller shaft.
Note: Secure one end of the brush assembly at a time
to simplify the following steps.
3. Adjust aggressiveness of the brush/scraper as fol-
lows:
A. Bristles touching the adjusting gauge bar gives
you an aggressive setting.
B. Adjusting the brush assembly so it is midway be-
tween the adjusting gauge bar and the cutting edge
of the bedknife will provide a medium setting.
C. Adjusting the brush assembly so it is even with
the cutting edge of the bedknife will provide a light
setting.
4. Tighten socket head screws securing clamp blocks
to roller shaft.
5. Adjust jam nuts on each scraper rod until there is a
clearance of approximately 1/32 inch (0.8 mm) between
the scraper and roller. Make sure scraper is parallel to
the roller.
1. Front roller bracket
2. Front
roller
3. Clamp block
4. Scraper rod
5. Socket head screw
6. Jam
nut
Figure 35
5
4
1
6
3
2