Toro GeoLink 41623, Quick Start Manual

Page: 4 / 4

g031494
1
2
3 4
Figure 7
1. Current rate 3. Decrease and increase
icons
2. Preset-rate icons
4. Sprayer-controller icon
6. Select the job-menu icon in the upper right of the
screen.
7. Enter a new name for the job or leave the default time
stamp (
Figure 8 ).
g031484
1
2
3
Figure 8
1. Job-menu icon 2. Enter a new name or use
the default time stamp
8. Open the job-menu icon.
9. Select the work region you are going to spray (i.e.
fairways, greens, tees, etc.) (
Figure 9 ).
g031485
1
3
2
Figure 9
1. Job-menu icon 3. Select the job region
2. Configure-job regions icon
10. Select the excluded regions that are not to be sprayed
(bunkers, trees, hazards, etc.)
Note:
Refer to the standard mode videos for spraying
a boundary inside another boundary.
11. Turn the section switches (located between the seats)
to the
ON
position ( Figure 10 ).
g031290
1 2 3
Figure 10
1. Boom switch, left boom 3. Boom switch, right boom
2. Boom switch, center boom
12. To start spraying, turn on the master-switch icon (the
master-switch turns green) and drive into the spray
area (
Figure 2 ).
Note:
The machine starts spraying when the sprayer
crosses into the correct spray area.
Note:
The display shows areas to be sprayed with
light gray and non-spray areas with a dark gray. If the
display shows all light gray, every area can be sprayed.
Note:
The display, receiver, and section controller will
power down when the machine key is turned to the
OFF
position. A power switch (green) for the display is
located on the back, left side of the console.
4