26
m–5921
2
4
4
1
3
Figure 22
1. Nut
2. Oil cooler
3. Front screen
4. Shoulder bolts
8.
When finished, install the front screen with the 4 bolts
removed previously.
9.
Install the oil cooler to the front screen with the 4
shoulder bolts and nuts removed previously.
10.
Slide the front screen between the frame and the front
weight and secure it to the grill using the carriage bolts
and nuts removed previously (Fig. 20).
11.
Tighten the bolts securing the front weight (Fig. 20).
12.
Install the side screens and close the hood.
Adjusting the Controls
The factory adjusts the controls before shipping the
traction unit. However, after many hours of use, you may
need to adjust the traction control alignment, the neutral
position of the traction control, and the tracking of the
traction control in the full forward position.
Important
To adjust the controls properly, complete
each procedure in the order listed.
Adjusting the Traction Control Alignment
If the traction control bar does not rest flush and square
with the reference bar when in the full backward position,
immediately complete the following procedure:
1.
Park the traction unit on a flat surface and lower the
loader arm.
2.
Stop the engine and remove the key.
3.
Pull straight back on the traction control so the front of
the control contacts the reference bar (Fig. 23).
m–7878
1
2
Figure 23
1. Front of the control, out of
alignment
2. Reference bar
4.
If the front of the traction control does not rest square
and flush with the reference bar, loosen the flange nut
and bolt in the stem of the traction control (Fig. 24).
m–7879
2
1
Figure 24
1. Traction control
2. Stem , bolt and nut
5.
Adjust the traction control so that it rest flush against
the reference bar when it is pulled straight back
(Fig. 24 and 25).
m–7880
Figure 25
6.
Tighten the flange nut and bolt in the traction control
stem.
Adjusting the Traction Control Neutral
Position
If the traction unit creeps forward or backward when the
traction control is in neutral and the unit is warm,
immediately complete the following procedure:
Summary of Contents for Dingo TX 420
