Toro CM-1258Y-SD, Operator'S Manual

Page: 9 / 40

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
Tow pole kit (sold separately) 1 Install the tow pole.
Safety chain 1
2
Connecting link 2
Install the safety chain.
1
Installing the Tow Pole
Parts needed for this procedure:
1 Tow pole kit (sold separately)
Installing the Tow Pole to the
Machine
Note:
The tow pole is purchased separately and
includes the nut and bolt needed for installation.
The machine has the following tow pole options:
Hitch Type Length
50 mm (2 inch) ball—stamped 127 cm (50 inches)
50 mm (2 inch) ball—forged 127 cm (50 inches)
Pintle 127 cm (50 inches)
1. Remove the bolt and nut from the tow pole
(
Figure 3 ).
g019804
Figure 3
1. Tow pole 4. Bolt hole
2. Front post 5. Frame fitting
3. Bolt 6. Nut
2. Slide the tow pole forward and align the hole in
the pole with the hole in the frame fitting (
Figure
3 ).
3. Insert the bolt through the holes in the fitting and
the pole (
Figure 3 ).
4. Thread the nut onto the bolt and tighten them
until they are tight against the frame fitting
(
Figure 3 ).
Note:
If the self-locking nylon insert in the
locknut wears with use, replace the nut with a
new Grade 5 or Grade 8 locknut.
9