8
1290
1
3
2
5
4
Figure 3
1.
Upper section
2.
Lower section
3.
Bolt, 5/16 x 5/8 inch
4.
Washer, 5/16 inch
5.
Locknut, 5/16 inch
3. Install the discharge chute worm gear assembly into the
slot on the leftside of the housing and locknut
(5/16 inch) (Fig. 4).
4. Adjust the rotator assembly so that the worm gear is at a
right angle with the chute, the chute teeth mesh fully,
and the chute turns freely (Fig. 4).
5. Tighten the locknut securely (Fig. 4).
4
1
2
3
m–7121
Figure 4
1.
Worm gear assembly
2.
Locknut, 5/16 inch
3.
Worm gear
4.
Chute teeth
Installing the Lift Tube to the
Snowthrower
1. Install the lift tube to the snowthrower frame with a
clevis pin and a pin clip (Fig. 5 and 6).
2
1
3
m–7069
Figure 5
1.
Lift tube
2.
Clevis pin
3.
Pin clip
2. Install the 2 eyebolts and 2 locknuts (3/8 inch) to the
end of the lift tube (Fig. 6). Install the eyebolt so the
threaded end is flush with the locknut.
3. Install 2 washers (5/8 inch) onto the lift rod and then
install the lift rod into the lift tube (Fig. 6 and 18).
m–7076
2
3
5
4
1
Figure 6
1.
Lift tube
2.
Eyebolt
3.
Locknut, 3/8 inch
4.
Washers, 5/8 inch
5.
Lift Rod
Installing the Idler Pulley
Bracket
1. Install the bracket handle into the hole in the side of the
housing and align the holes in the frame and idler pulley
bracket (Fig. 7).
2. Secure the idler pulley bracket to the frame with a bolt
(3/8 x 1–1/4 inch) and a locknut (3/8 inch).
Summary of Contents for 79482
Page 27: ......
