19
m–7071
2
3
1
Figure 32
1.
Snowthrower
2.
Cover
3.
Bolt
4. Clean the grease fittings with a rag.
5. Scrape any paint off the front of the fittings.
6. Connect a grease gun to each fitting in turn and pump
grease into them.
m–7080
Figure 33
m–7079
Figure 34
7. Wipe up any excess grease.
8. Install the cover onto the snowthrower (Fig. 32).
Oiling the Drive Chain and Discharge
Chute
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the cover from the snowthrower (Fig. 32).
4. Coat the entire chain with oil and allow it to penetrate
each roller (Fig. 35).
m–7079
Figure 35
5. Place a few drops of oil on the discharge chute rotator
shaft and discharge chute mounting (Fig. 36).
m–7126
Figure 36
6. Wipe off excess oil.
7. Install the cover onto the snowthrower (Fig. 32).
Adding Gear Box Lubricant
1. Move the snowthrower to a level surface.
2. Disengage the PTO and set the parking brake.
Summary of Contents for 79482
Page 27: ......
