13
2. Pull attachment lift lever rearward, to release lift
pressure, and push the button on top to release the latch.
Move lift lever forward to lower attachment.
m–2514
3
2
1
Figure 20
1.
Lift lever
2.
Button
3.
Dial-A-Height
Operating the Attachment
Power Lift
The attachment power lift (Fig. 21) is used to raise and
lower attachments.
Raising Attachments
1. Start the engine, refer to; Starting and Stopping the
Engine; in tractor Operator’s Manual.
2. Pull the lift lever in the up direction to raise the
attachment lift (Fig. 21). This will lift and hold the
attachment in the up, or raised position.
Lowering Attachments
1. Start the engine, refer to; Starting and Stopping the
Engine; in tractor Operator’s Manual.
2. Push the lift lever in the down direction to lower the
attachment lift (Fig. 21).
m–2454
2
1
Figure 21
1.
Lift lever— UP
2.
Lift lever— DOWN
Adjusting Dial-A-Height
The Dial-A-Height control (Figs. 20) is used to limit the
downward travel of the attachment, on gear drive tractors
only. The Dial-A-Height knob is rotated to change the
location of this stop, up or down.
1. Raise the attachment lift lever: Refer to Raising
Attachments. In the raised position the Dial-A-Height
knob (Fig. 20) can be rotated to change the stop
location. Turn clockwise to raise and counterclockwise
to lower the height of the attachment.
2. The Dial-A-Height indicator (Fig. 20) will show the
change, high to low, in attachment lift height as
adjustment is made.
Adjusting Lift Chain
Danger
Rotating tines can cause injury to hands, feet or
other body parts.
•
Keep away from the rotating tines while
operating the tiller.
•
Keep your hands, feet, and any other part of
your body or clothing away from rotating parts.
•
Before adjusting, cleaning, repairing and
inspecting the tiller, shut off the engine and wait
for all moving parts to stop. Move the power
take off (PTO) to the off position and turn the
engine off. Remove the key.
Changing the lift chain link location at the lift arm notch,
affects maximum tilling depth, transport lift height and lift
effort. The location can be changed at the lever (Fig. 22).
