Installation
11
m–4230
ÉÉÉÉ
ÉÉÉÉ
ÉÉÉÉ
ÉÉÉÉ
2
1
Figure 19
1.
Pulley outside diameter
2.
Wide side of belt
A.
Replace the right side panel and close the
hood.
11. On the right side of the tractor, pull forward on
the spring tension lever and connect the spring
tension link to the keyhole slot in the
snowthrower frame (Fig. 20).
m–4346
1
2
3
4
Figure 20
Right side of tractor shown
1.
Spring tension link
2.
Spring tension lever
3.
Snowthrower frame
4.
Keyhole slot
12. Open the latches on the rear Attach-A-Matic
hitch. Put the support rod link into the front
notches on the rear Attach-A-Matic
hitch and
close the latches to secure it in place (Fig. 21).
13. Slide the non adjusting ends of the two support
braces onto the support rod link that is now in
the rear Attach-A-Matic
hitch mount.
•
Make sure the rod of each brace faces
inward.
•
Secure the braces to the rod with a 13/16”
(21 mm) washer and a large hairpin cotter
(Fig. 21).
m–3724
1
2
3
4
5
6
7
Figure 21
1.
Support rod link
2.
Rear Attach–A–Matic
hitch
3.
Front of tractor
4.
Rear Attach–A–Matic
hitch latch
5.
Support brace
6.
Washer 13/16” (21 mm)
7.
Hairpin cotter–large
14. Secure the other ends of the support braces to the
frame rods protruding from the mid
Attach-A-Matic
hitch with a 15/16” (24 mm)
washer and a large hairpin cotter (Fig. 22). You
may need to turn the adjuster of each brace
before the holes in the adjuster align with the
frame rod.
