7
DESCRIPTION
QTY.
USE
Snowthrower assembly
Lift tube
Lift rod
Spacer washer, 13/16 in.
Washer, 5/8 in.
Hairpin cotter-large
Lift assist spring
Eyebolt
Locknut, 3/8 in.
Crank handle
Handle support
Hairpin cotter-small
1
1
1
2
1
1
1
1
1
1
1
2
Installing the snowthrower to tractor
Belt
1
Installing the snowthrower belt
Assembling the Housing
1. Tip the housing onto it’s front and insert frame into
snowthrower with angle bend up. Fasten frame with 4
bolts (3/8 x 1 in.) (heads to the outside) and 4 locknuts
(3/8 in.) (Fig. 2).
2. Install pulley so the hub is towards the inside of
snowthrower and secure it with a square key and 2 set
screws (5/16 x 1/2 inch) (Fig. 2).
Important
Key must be located under a set screw to
be retained.
3. Install tension spring between frame and idler arm
(Fig. 2).
1
3
2
4
7
9
8
6
5
10
m–7286
Figure 2
1.
Housing
2.
Frame
3.
Bolt, 3/8 x 1 in.
4.
Locknut, 3/8 in.
5.
Pulley hub
6.
Square key
7.
Set screw, 5/16 x 1/2 in.
8.
Spring
9.
Idler arm
10. Drive shaft
Installing the Top and Side
Plates
1. Rotate the housing down and position top plate outside
top flange of housing. Secure with 3 carriage bolts
(3/8 x 1 in.) (heads to the inside), 3 washers (3/8 in.)
washers, and 3 locknuts (3/8 in.) (Fig. 3).
