Installation
6
Tractor Set-Up
1.
Remove E–ring and all except one thick washer
from tractor front axle pivot pin. Discard unused
washers. (Fig. 6). Remove muffler shield.
2.
Install (4) 3/8 x 1 carriage bolts into keyhole
slots in axle bracket. Install muffler shield and
place front hitch onto the tractor securing with
(4) 3/8” washers, (4) 3/8” lock nuts and
previously removed E-ring (Fig. 6).
1
2
1287
4
3
5
6
7
Figure 6
1.
E-ring
2.
Thick Washer (existing)
3.
Axle pivot
4.
Front hitch
5.
Carriage bolt 3/8 x 1”
6.
Washer 3/8”
7.
Lock nut 3/8”
3.
Assemble rear mounting plate and blade bracket
with (2) 1/2 x 1-1/4” bolts (heads toward the
rear) and (2) 1/2” lock nuts through holes in
vertical plates (Fig. 7).
4.
For blade use latch levers must be installed onto
the blade bracket (Fig. 7). If necessary remove
latch levers from rear mounting plate and move
to the blade bracket. Secure with previously
removed hardware (Fig. 7).
IMPORTANT: Do not tighten nut and bolt
excessively to cause binding of levers at bracket.
2
3
1
1466
7
6
8
4
5
Figure 7
1.
Rear mounting plate
2.
Blade bracket
3.
Bolt 1/2 x 1-1/4”
4.
Lock nut 1/2”
5.
Carriage bolt 3/8 x 1-1/4”
6.
Washer 3/8”
7.
Latch lever
8.
Lock nut 3/8’
Summary of Contents for 79252
Page 19: ......
Page 20: ...42680081 8 95 ...
