Toro 79252, Operator'S Manual, Page: 7 / 20

Installation
5
5. Attach index lever to frame bracket with 1/2 x 1”
bolt and 1/2” nut (Fig. 3).
IMPORTANT: Do not tighten nut and bolt
excessively to cause binding of lever at bracket.
6. Install eye bolt and eyelets with (2) #10 washers
and (2) #10 lock nuts(Fig. 3).
7. Thread jam nut and turnbuckle onto cable and
hook into handle lever(Fig. 3).
8. Route cable through eyebolt and eyelet and
attach Z end to back hole of index plate (Fig. 3).
9. Adjust turnbuckle so the index pin is pulled out
of channel when the release lever is squeezed,
for easy side-to-side movement (Fig. 3). Tighten
jam nut securely.
10. Attach one end of control rod to index lever with
1/2” washer and hairpin cotter. (Fig. 3).
2288
4
6
9
12 13 2
4
10
3
1
14
5
7
11
8
Figure 3
1. Index lever
2. Bolt 1/2 x 1”
3. Nut 1/2”
4. Cable Z end
5. Eyelet
6. Eyebolt
7. Lock nut and washer #10
8. Handle lever
9. Back hole of index plate
10. Turnbuckle
11. Jam nut
12. Control rod
13. Washer 1/2”
14. Hairpin cotter
11. Insert control rod, end with welded washer, thru
hole in bottom plate of channel weldment
(Fig. 4). Secure with cotter pin, between the
plates.
1
1467
3
2
Figure 4
1. Control rod
2. Plate
3. Cotter pin
12. Place front lift weldment between frame and
attach captured plate to frame with (2) 3/8 x 1”
bolts and (2) 3/8” lock nuts (Fig. 5).
13. Slide remaining plate over shaft and secure to
frame with (2) 3/8 x 1”bolts and (2) 3/8”lock
nuts. Secure lift assembly shaft to plate with
5/8” washer and cotter pin (Fig. 5).
14. Attach lift rod to lift weldment and secure with
5/8” washer and cotter pin (Fig. 5).
1246b
1
2
3
3
4
4
5
7
6
7
8
8
Figure 5
1. Lift weldment
2. Captured plate
3. Bolt 3/8 x 1”
4. Lock nut 3/8”
5. Plate
6. Lift rod
7. Washer 5/8”
8. Cotter pin