Form No. 3367-636 Rev A
42in Recycler
®
Kit
2007 and After Riding Mower
Model No. 79018
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the mower.
Upper baffle
1
Bolt (5/16 x 5/8 inch)
3
Flange-head nut (5/16 inch)
3
Bolt (1/4 x 5/8 inch)
4
2
Locknut (1/4 inch)
4
Install the upper baffle.
Kicker plate
3
3
Phillips head screw (#8 x 5/8 inch)
6
Install the kicker plates.
Discharge cover
1
Bolt (1/4 x 2-1/2 inches)
2
4
Cap nut (1/4 inch)
2
Install the discharge cover.
5
Recycling decal
1
Instal the decal.
6
Recycling mower blade
2
Install the blades and mower
1
Preparing the Mower
No Parts Required
Procedure
1. Stop the engine and remove the ignition key.
2. Remove the mower as described in your
Operator’s
Manual
.
3. Turn the mower upside down.
4. Remove the mower blades as described in your
Operator’s Manual
.
5. Locate the holes illustrated in Figure 1 and proceed
as follows:
•
If any of the holes have fasteners in them,
remove the fasteners.
•
If any of the holes have rivets in them, drill out
the center of each rivet with a 3/16 inch (5 mm)
drill bit and discard the rivet.
© 2010—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
