9
1
m-3209
3
2
Figure 13
1.
Spring Assembly
2.
Shoulder Bolt 3/8 x 7/8 in.
(22 mm)
3.
Locknut 3/8 in.
4. Carefully lower mower from vertical position using
front lift handles, refer to: Tilting the Mower.
5. Remove hairpin cotters and clevis pins from mower
hanger brackets and remove mower from carrier frame
(Fig. 14).
1
m-3199
3
2
Figure 14
1.
Mower Hanger Bracket
2.
Clevis Pin
3.
Hairpin Cotter
6. Raise the carrier frame and roll the mower away from
traction unit.
7. Lower carrier frame and remove hairpin cotters and
pivot pin assemblies securing push arms to traction unit
clevises (Fig. 15).
Note: Save all hardware for use when installing mower.
2
4
3
m-4870
1
Figure 15
1.
Clevis
2.
Push Arm
3.
Pivot Pin Assembly–flat
4.
Hairpin Cotter
8. Remove 2 bolts (3/8 x 1-5/8 in. (41.5 mm)) and
locknuts (3/8 in.) from universal joint and slide the
driveshaft off gearbox shaft (Fig. 16).
Note: Save all hardware for use when installing mower.
1
2
4
m-3198
3
5
Figure 16
1.
PTO Driveshaft
2.
Universal Joint
3.
Gearbox shaft
4.
Bolt, 3/8 x 1-5/8 in.
(41.5 MM)
5.
Locknut, 3/8 in.
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
Operating the Power Take Off
(PTO)
Refer to your traction unit operator manual for the proper
engaging and disengaging of the PTO.
