![background image](http://html1.mh-extra.com/html/toro/78449/78449_operators-manual_1133861004.webp)
4
Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use the chart below to identify parts used for assembly.
Description
Qty.
Use
Discharge chute
Nylon washer, 3/8 in.
Spring
Rubber bushing
Flat washer, 1/2 in.
Locknut, 3/8 in.
Cotter pin, 3/4 in.
1
2
1
1
1
1
1
Install the discharge chute
Pulley box
PTO drive belt
1
1
Install the PTO drive belt
Assembling the Mower
Installing the Discharge Chute
1. Place the short end of the spring into the small hole in
the discharge chute (Fig. 2).
1
3
2
5
4
6
m-3144
7
8
10
9
Figure 2
1.
Discharge chute
2.
Spring
3.
Cotter pin, 3/4 in.
4.
Washer, 1/2 in.
5.
Rubber bushing
6.
Plastic washer
7.
Jam nut, 3/8 in.
8.
Loop in spring
9.
Post on mower housing
10. Stud on mower housing
2. Position the spring and discharge chute over the post on
the rear of the mower and secure them with a washer
(1/2 in.) and a cotter pin (3/4 in.) (Fig. 2).
3. Ensure that the loop in the spring slides over the stud on
the mower housing.
4. Slide the rubber bushing and nylon washer over the stud
at the front of the mower.
5. Place the discharge chute over the stud and secure it
with a second nylon washer and a locknut (3/8 in.)
(Fig. 2).
6. Tighten the locknut flush with the end of the stud.
Important
The discharge chute must be spring loaded
in the down position. Lift the chute up and release it to test
that it snaps to the full down position.
Danger
Without the grass deflector, discharge cover, or
complete grass catcher assembly mounted in place,
you and others are exposed to blade contact and
thrown debris. Contact with the rotating mower
blades and thrown debris will cause injury or
death.
•
Never remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the grass
deflector is ever damaged, replace it
immediately.
•
Never put your hands or feet under the mower.
•
Never try to clear the discharge area or mower
blades unless you move the power take off
(PTO) to Off and rotate the ignition key to Off.
Also remove the key and pull the wires off of the
spark plugs.