15
Grass Collector Warning Light
When the grass collector needs to be emptied, the warning
light comes on (Fig. 5) and a buzzer sounds.
Important
To prevent the discharge tunnel from getting
clogged, disengage the blades (PTO) when the warning
light and buzzer are on.
Setting the Height of Cut
Use the height-of-cut lever to raise and lower the mower to
the desired cutting height. You can set the cutting height to
7 different positions from approximately 1
to 4 in.
(25 to 102 mm).
Pull or push on the height-of-cut lever and shift it into the
desired position (Fig. 6).
1
Figure 6
1. Height-of-cut lever
Important
You must set the height-of-cut lever to the
highest position (7) when you transport the tractor off the
lawn to prevent damaging to the blades.
Adjusting the Discharge Baffle
The discharge baffle changes the size of the discharge
opening to assist the operation of the bag fill indicator.
1.
Remove the grass collector; refer to Removing the
Grass Collector on page 36.
2.
Loosen the 2 nuts on the mowing conditions plate and
slide the plate up if you are mowing short, dry grass or
slide it down if you are mowing long, wet grass (Fig. 7).
m-4934
1
2
Figure 7
1. Plate
2. Nuts
3.
Tighten the nuts.
4.
Install the grass collector; refer to Installing the Grass
Collector on page 36.
Adjusting the Mower Gauge
Wheels
The mower front gauge wheels guide the mower over
uneven ground. The mower wheels must always be in the
bottom (lowest) hole in the wheel bracket (Fig. 8).
1
2
Figure 8
1. Wheel
2. Bottom hole
