![background image](http://html1.mh-extra.com/html/toro/74237/74237_operators-manual_1133858046.webp)
4. Move the motion control lever forward and
reverse, then back to neutral. The wheel must
stop turning or slightly creep in reverse.
5. Open the throttle to fast. Make sure the wheel
remains stopped or slightly creeps in reverse,
adjust if necessary.
6. Tighten the locknuts at the ball joints
Electrical system will not perform proper
safety shut off with jumper wire installed.
•
Remove jumper wire from wire
harness connector and plug
connector into seat switch when
adjustment is completed.
•
Never operate this unit with jumper
installed and seat switch bypassed.
7. After both pump neutrals are set, shut off the
machine.
8. Remove the jumper wire from the wire harness
connector and plug the connector into the seat
switch.
9. Install the seat rod and lower the seat into
position.
10. Remove the jack stands.
Mower Deck
Maintenance
Leveling the Mower at Three
Positions
Important:
There are only three measuring
positions needed to level the mower.
Setting Up the Machine
1. Position mower on a flat surface.
2. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
3. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
4. Check tire pressure of all four tires. If needed,
adjust to 13 psi (90 kPa)
5. Lower the mower to the 3 inch (76 mm)
height-of-cut position.
6. Inspect the four chains. The chains need to
have tension.
Note:
Adjust the rear chains to the top of the
slot, where they are attached to the mower.
•
If one rear chain is loose, lower (loosen) the
front support arm on the same side. Refer
to Adjusting the Front-to-Rear Mower
Pitch.
•
If one front chain is loose, raise (tighten)
the front support arm for that chain. Refer
to Adjusting the Front-to-Rear Mower
Pitch.
Leveling the Mower Side-to-Side
1. Position the
right
blade front-to-rear
Figure 60
1. Measure here from blade
to hard surface
2. Measure at B and C
2. Measure the right blade at the
B
location, from
a level surface to the cutting edge of the blade
tip (Figure 60).
3. Record this measurement. This measurement
needs to be 3-1/8 to 3-1/4 inches.
4. Position the left blade front-to-rear (Figure 60).
5. Measure the left blade at the
C
location
(Figure 60), from a level surface to the cutting
edge of the blade tip .
6. Record this measurement. This measurement
needs to be 3-1/8 to 3-1/4 inches.
46
Summary of Contents for 74237
