Maintenance
24
Greasing and Lubrication
Service Interval/Specification
Grease the machine after every 50 operating hours or
yearly, whichever occurs first. Grease more frequently
when operating conditions are extremely dusty or
sandy.
Grease Type: General-purpose grease.
How to Grease
1.
Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
“OFF” to stop the engine. Remove the key.
2.
Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
3.
Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
4.
Wipe up any excess grease.
Where to Add Grease
1.
Lubricate the front wheels and spindles until
grease begins to ooze out of the bearings
(Fig. 23).
2.
Lubricate the front axle pivot (Fig. 23).
1211
Figure 23
3.
Lubricate the traction control pedal on
hydrostatic models (or brake and clutch pedals
on gear drive models) where they pivot on
mounting shaft (Fig. 24).
1264
Figure 24
Tire Pressure
Service Interval/Specification
Maintain the air pressure in the front and rear tires as
specified. Check the pressure at the valve stem after
every 25 operating hours or monthly, whichever
occurs first (Fig. 25). Check the tires when they are
cold to get the most accurate pressure reading.
Pressure: 12 psi (.85 kPa) front and rear
1
2323
Figure 25
1.
Valve stem
Summary of Contents for 72110
Page 7: ...Safety 5 Slope Chart Read all safety instructions on pages 2 8...
Page 36: ...Maintenance 34 Wiring Diagram...
Page 40: ......
