Introduction
The 690 Series Rotary Sprinkler is designed for irrigation of large turf areas such as golf courses, parks,
recreational fields and school grounds.
Manufactured from durable, high strength engineering plastic and stainless steel components, the 690 sprinkler
incorporates many innovative and time proven features for lasting, maintenance-free operation. Some of these
features are listed below.
INSTALLATION & SERVICE INSTRUCTIONS
690 Series Rotary Sprinkler
Features
• Positive Spring Retraction - Pulls nozzle and cap down out of the
way of people and turf maintenance equipment.
• Three Nozzle Sizes - Multiple nozzle sizes provide 45.1 to 82.2 GPM
flow and produce watering radii from 78 to 108 feet.
• Long Life Gear Drive - Gear drive mechanism is vacuum-packed with
lubricant and isolated from water stream for long, trouble-free life.
• Valve-In-Head Models - Permits head-by-head control to customize
turf watering for various topography and soil conditions. Multi-cycle for
wind or runoff problems, frost control and dew removal without low-head
drainage. Available for hydraulic normally open or 24 Volt electric
systems.
• Sprinkler Operating Mode - Electric valve-in-head models have three
modes of operation; AUTO, ON and OFF. Mode is set using a selector
tool inserted through the sprinkler body flange.
• Built-in Check Valve - Check-o-matic sprinklers utilize a check valve in
the sprinkler base to prevent seepage from low area heads after valve
closure. Check valve will hold up to 35 feet of elevation differential.
• Two-Speed / 60°-120° Models -Provides for more even precipitation.
Runs at half speed in non-overlapping areas.
• Two-Speed / 180° Models -Provides for more even precipitation
where only a selected area is covered by an overlap, such as is found on
greens. Runs at half speed in non-overlapping areas.
• Serviceability -All internal parts of the sprinkler are accessible through
the top of the sprinkler body.
Model 69X-06-XX
Model 69X-02-XX
Model 69X-01-XX
Specifications
• 78 ft. – 108 ft. Radius
• Pop-Up Nozzle and Cap -
7
⁄
8
in.
• 1
1
⁄
2
in. NPT Female Thread Inlet
• Recommended Operating
Pressure: 60 – 100 PSI
• Maximum Pressure: 150 PSI
• Electric Models:
– Solenoid - 24 VAC
– Inrush Current - .40 Amps
– Holding Current - .235 Amps
• Dimensions:
– Cap Diameter - 7
1
⁄
2
in.
– Flange Diameter - 10 in.
– Height - 16 in.
All manuals and user guides at all-guides.com
all-guides.com
