Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Guard
1
Phillips screw
2
Washer
2
2
Lock washer
2
Mount the guard to the base of the
trimmer.
3
Edge guard
1
Install the edge guard.
Auxiliary handle
1
Latch
1
4
Brace
1
Install the auxiliary handle.
5
No parts required
–
Adjusting the handle height.
1
Assembling the Trimmer
No Parts Required
Procedure
1.
Slide the upper pole into the lower pole, lining up the groove
in the upper pole with the groove in the lower pole, and
tighten the screw so that the upper pole remains secure
during operation (
Figure 1
).
Note:
Use a 10 mm wrench to tighten the screw.
Note:
The upper pole should bottom out in the lower
pole.
Figure 1
1.
Upper pole
4.
3 mm (1/8 inch) gap
2.
Clamp
5.
Lower pole
3.
Screw
2.
Cut the cable tie away from your body and remove it from
the trigger handle (
Figure 2
).
Figure 2
1.
Cable tie
5
