Figure 23
1.
Supply hose
3.
Retainer pin
2.
Eductor valve assembly
5.
Install the open end of the hose into the eductor valve
and secure the hose using a retainer pin (
).
6.
Slide the hose clamp over the fitting barb, and tighten
the clamp to secure the fitting to the hose.
7
Finishing the Installation
Parts needed for this procedure:
1
Suction lance and hose (optional)
Procedure
Note:
The suction lance and hose are optional accessories.
Contact your Authorized Toro Distributor for more
information.
Retain the suction lance and hose for later use. Read and
retain the remaining documentation on using the Chemical
Pre-Mix Kit.
13
Summary of Contents for 41622
Page 18: ...Notes 18...
