g248021
Figure 7
4.
Squeeze the lever fully, then check the gap
between the bottom of the handle and the end
of the wheel-clutch lever (
).
g001306
Figure 8
Note:
The gap should be approximately the
thickness of a pencil (1/4 inch or 6 mm). If it is
greater, loosen the cable-clamp nut, slide the
cable jacket up slightly, tighten the cable-clamp
nut, and check the gap again.
5.
Repeat steps 2 through 5 for the other cable.
3
Installing the Traction-Control Linkage
No Parts Required
Procedure
g263628
7
Summary of Contents for 38841
Page 14: ...g322740 Figure 18 Recoil Start g257505 Figure 19 14 ...
Page 30: ...Notes ...
Page 32: ......
