Toro 38841, Operator'S Manual

Page: 22 / 32

Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Inspect the
auger/impeller cable and adjust it if
necessary.
Yearly—Inspect the auger/impeller cable and
adjust or replace it if necessary.
1. Remove the 2 screws that are holding the belt
cover in place (
Figure 34 ).
2. Remove the belt cover ( Figure 34 ).
g260066
Figure 34
3. With the auger/impeller lever disengaged,
ensure that the gap between the auger clutch
arm and the frame of the machine is 1.5 mm
(1/16 inch) as shown in
Figure 35 .
g260108
Figure 35
1. 1.5 mm (1/16 inch) 3. Auger clutch arm
2. Frame
4. If the auger/impeller cable is not properly
adjusted, do the following steps:
5. Loosen the jam nut ( Figure 36 ).
g322960
Figure 36
1. Jam nut 2. Turnbuckle
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable (
Figure 36 ).
7. Adjust the turnbuckle until you obtain the proper
gap.
8. Tighten the jam nut.
9. Insert the 2 screws that you previously removed
on the belt cover.
10. If the auger/impeller cable is properly adjusted
but a problem remains, contact an Authorized
Service Dealer.
22