6
3329-465
Installing the Handle
1.
Cut the plastic tie that secures the control cable
to the handle.
Note: Hold the cable taut to ensure that it stays
disconnected at the bottom.
2.
Position the upper handle as shown.
m5516
3.
Loosely
install the handle
bolts, curved
washers, and
knobs as shown.
m5573a
4.
Hook the end
of the control
cable into the
bottom hole of
the control bar.
m-5519
5.
Fully insert the handle bolts.
Important:
Ensure that you
do not pinch the
control cable.
6.
Tighten the
knobs until they
are snug.
m-6104a
7.
Adjust the control cable. Refer to Adjusting the
Control Cable on page 10.
Installing the Discharge
Chute
Install the discharge chute as shown.
m-6187
Installing the Chute Crank
1.
Insert the end of the chute crank (A) through the
hole in the shroud (B) and align the mounting bracket
(C) with the holes in the lower handle.
2.
Slowly rotate the
crank until the end of
the chute crank fits
into the hidden gear
opening and the
discharge chute
turns with the crank.
Note: Ensure that
the plastic bushing
(D) is fully inserted
into the hole in the
mounting bracket.
3.
Secure the
mounting bracket to
the handle with
2 bolts and
2 locknuts.
A
C
m5545a
B
D
