g016499
Figure 23
5.
Pull the recoil starter 3 or 4 times.
Note:
This helps prevent the recoil starter from
freezing up.
Operating the Traction
Drive
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust it
properly, if necessary; refer to
Operation of the Traction Drive (page 7)
for
more information.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 18)
or take the machine
to an Authorized Service Dealer for service.
1.
To engage the traction drive, squeeze the left
(traction) lever to the handgrip (
g001011
Figure 24
2.
To stop the traction drive, release the traction
lever.
Operating the Speed
Selector
The speed selector has 6 forward and 2 reverse
gears. To change speeds, release the traction lever
and shift the speed-selector lever to the desired
position (
). The lever locks in a notch at
each speed selection.
g001012
Figure 25
Operating the
Auger/Impeller Drive
1.
To engage the auger/impeller drive, squeeze
the right (auger/impeller) lever to the handgrip
(
).
g001013
Figure 26
12
