Form No. 3429-633 Rev A
Homologation Kit
Groundsmaster
®
1200 Series Pull Behind Rotary Mower
Model No. 31950
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
Left taillight support
1
Right taillight support
1
Reflector triangle
2
Screw (#10-24 x 3/4 inch)
4
2
Locknut (#10-24)
4
Assemble the taillights.
Capscrew (5/16 x 4 inches)
4
Washer (5/16 inch)
4
3
Flange locknut (5/16 inch)
4
Assemble the taillights to the machine.
4
Wire harness bracket
2
Install the wire harness brackets.
5
Cable ties
4
Route and connect the wire harness.
6
No parts required
–
Connect the wire harness to the tow
vehicle.
1
Preparing the Machine
No Parts Required
Procedure
1.
Connect the machine to the tow vehicle; refer to
the
Operator's Manual
for the machine.
2.
Lower the mower decks; refer to the
Operator’s
Manual
for your machine.
3.
Engage the parking brake for the tow vehicle,
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operator’s seat.
4.
Lower the jack and disconnect the machine from
the tow vehicle; refer to the
Operator's Manual
for the machine.
5.
Chock the tires of the machine.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3429-633* A
