Toro 31529, Installation Instructions Manual

Page: 5 / 20

g021282
Figure 4
Side View—Groundsmaster 4500/4700
1. Bolts 6. Tube bracket
2. Chassis bracket
7. Pressure hose
3. Divider tube 8. Up
4. Nut 9. Forward
5. Clamp
g027294
Figure 5
Side View—Reelmaster 7000
1. Bolts 6. Tube bracket
2. Chassis bracket 7. Pressure hose
3. Divider tube 8. Up
4. Nut 9. Forward
5. Clamp
3. Remove the rear end of the pressure hose from
the fitting in the hydraulic pump, and remove
the pressure hose. See
Figure 2 and Figure
4 (Groundsmaster machines) or Figure 3 and
Figure 5 (Reelmaster machines).
4. Temporarily cap the pump and the divider tube.
Note:
Discard the original pressure hose.
Removing the Cross Tube
1. Align the drain pan below the rear-traction
manifold.
2. Remove the tube nut for the cross tube from the
fitting in the rear-traction manifold (
Figure 2 or
Figure 3 ).
3. Remove the tube nut for the filter tube from the
fitting in the cross tube, and remove the cross
tube (
Figure 2 or Figure 3 ).
Important:
Retain the filter tube for
installation in Installing the Filter Tube and
the Divider Tube (page 11) .
Note:
Discard the cross tube.
4. Temporarily cap the fitting in the rear-traction
manifold.
Removing the Tube Bracket and
Clamp
1. Remove the bolt and the nut that secure the
divider tube to the tube bracket, and remove the
clamp (
Figure 4 or Figure 5 ).
2. Remove the 2 bolts and the 2 nuts that secure
the tube bracket to the chassis bracket (
Figure 4
or Figure 5 ).
Note:
Discard the tube bracket, clamp, and
hardware.
5