Toro 31526, Installation Instructions Manual

Page: 6 / 20

Removing the Divider Tube
1. Remove the tube nut of the divider tube from
the T-fitting in the front, right traction motor, and
remove the tube from the machine (
Figure 7 ).
g212934
Figure 7
1. Tube nut (divider tube) 2. T-fitting (traction motor)
Note:
Discard the divider tube.
2. Temporarily cap the T-fitting in the traction motor.
Removing the Traction-Control
Hose
1. Remove the inboard-hose fitting for the
traction-control hose from the hydraulic fitting in
port (CH1) of the combination manifold (
Figure
8 ).
g212937
Figure 8
1. Hydraulic fitting (rear
traction manifold) 4. Hydraulic fitting
(combination manifold)
2. Outboard-hose fitting
(traction-control hose) 5. Combination manifold
3. Inboard-hose fitting
(traction-control hose) 6. Rear traction manifold
2. Remove the outboard-hose fitting for the
traction-control hose from the 45° hydraulic
fitting in port (CH) of the rear traction manifold.
3. Temporarily cap the straight hydraulic fittings in
the combination manifold and the 45° hydraulic
fitting in the rear traction manifold.
Note:
Discard the traction-control hose.
6