Toro 31526, Installation Instructions Manual

Page: 10 / 20

3. Align the straight fitting of the cross hose with
the 45° hydraulic fitting in the rear traction
manifold (
Figure 14 ).
4. Remove the cap from the 45° hydraulic fitting in
the rear traction manifold that you installed in
step
3 of Removing the Traction-Control Hose
(page 6) .
5. Thread the hose fittings of the cross hose onto
the fittings of the T-fitting and the rear traction
manifold, and tighten the fittings to 51 to 63 N∙m
(37 to 47 ft-lb).
Installing the Rear Traction Hose
1. Align the fitting of the rear traction hose through
the cushioned guide of the support bracket, and
slide the hose through the bracket (
Figure 15 ).
g212930
Figure 15
1. Bulkhead 4. Cushioned guide
2. Bulkhead fitting 5. Rear traction hose
3. Support bracket
2. Align the rear fitting of the rear traction hose with
the bulkhead fitting (
Figure 16 ).
g212974
Figure 16
1. Bulkhead 4. Forward fitting (rear
traction hose)
2. Bulkhead fitting 5. Straight hydraulic fitting
3. Rear fitting (rear traction
hose) 6. Flow-divider manifold
3. Align the forward fitting of the rear traction hose
with the straight hydraulic fitting located in port
M3 of the flow-divider manifold (
Figure 16 ).
4. Remove the cap from the bulkhead fitting that
you installed in step
3 of Removing the Hydraulic
Hoses (page 4) .
5. Thread the hose fittings of the rear traction hose
onto the fittings in the flow-divider manifold and
the bulkhead fitting, and tighten the fittings to
116 to 142 N∙m (85 to 105 ft-lb).
10