g036666
g225685
Figure 28
1.
Bypass valves
2.
Rotate each valve 3 turns counter-clockwise to
open and allow the oil to bypass internally.
Note:
Do not open more than 3 turns. Because
fluid is bypassed, you can slowly move the
machine without damaging the transmission.
3.
Close the bypass valves before starting the
engine.
4.
Torque to 70 N∙m (52 ft-lb) to close the valve.
Important:
To push or tow the machine in reverse,
you must bypass the check valve in the 4-wheel
drive manifold. To bypass the check valve,
connect a hose assembly to the reverse traction
pressure test port, located on the hydrostat, and
on the port located between ports M8 and P2 on
the rear traction manifold, which is located behind
the front tire. The hose assembly includes 1 hose
(Part No. 95-8843), 2 coupler fittings (Part No.
95-0985), and 2 hydraulic fittings (Part No. 340-77).
Locating the Tie-Down
Points
Note:
Use properly-rated DOT-approved straps in 4
corners to tie down the machine.
•
On each side of the frame by the operator’s
platform
•
On the rear bumper
g036664
Figure 29
g036665
Figure 30
37
