g001455
Figure 16
1.
Axle-pivot bolt
2.
Axle-adjustment bolt
4.
Place a jack under the rear center of the engine
frame. Raise the rear end of the engine frame
up enough to remove the front 2 axle-adjustment
bolts (
Note:
Use jack stands to support the machine.
5.
Raise or lower the engine frame with the jack so
that you can install the front 2 axle-adjustment
bolts in the desired hole location (
).
Note:
Use a tapered punch to help align the
holes.
6.
Tighten all 4 bolts and lower the machine.
7.
Adjust the control rods and brake linkages as
required; refer to
(page 21)
and
(page 33)
.
Important:
You must adjust the control rods
and brake linkage when you change the
axle positions for proper traction and brake
function.
Adjusting the Caster Position
1.
Using the
Height-of-Cut Chart (page 22)
, adjust
the caster spacers to match with the axle hole
selected (
).
g001456
Figure 17
1.
Latch pin
3.
Spacer (13 mm or 1/2 inch)
2.
Spacer (5 mm or 3/16 inch)
2.
Remove the latch pin, slide the caster from the
support, and change the spacers (
3.
Install the caster in the support and insert the
latch pin (
20
Summary of Contents for 30672
Page 45: ...Schematics g001471 Electrical Schematic Rev A 45...
Page 46: ...Notes...
Page 47: ...Notes...
