3
Installing the Turn Signal and
Hazard Switches
Parts needed for this procedure:
1
Switch, turn signal
1
Switch, hazard
1
Wire harness, platform
Procedure
1.
From the under side the steering tower dash panel,
press the plugs out of the holes shown in Figure 3.
Note:
On models 30602, 30603, 30606 and 30607 the
turn signal and hazard switches are already installed on
the machine. Skip to Step 4.
g021754
Figure 3
1.
Remove these hole plugs
2.
Install the turn signal switch into the lower hole in of
the steering tower dash panel (Figure 4). The turn
signal switch is a On-Off-On switch.
g021714
1
2
Figure 4
1.
Hazard switch
2.
Turn signal switch
3.
Install the hazard switch into the upper right hole in the
steering tower dash panel (Figure 4). The hazard switch
is a On-None-On switch and has a hazard symbol on it.
4.
Plug the connector body from the enclosed platform
wire harness into the wire harness under the steering
cover opening.
Note:
On models 30602, 30603, 30606 and 30607,
unplug the existing wire harness connectors from the
turn signal and hazard switches.
5.
Plug the connectors from the platform wire harness
into the connectors from the flasher module, turn
signal and hazard switches (Figure 2).
6.
Secure the wire harness.
Note:
When routing the wires, ensure that the
operation of the tilt steering does not damage the
harness or pull on the wires.
4
Summary of Contents for 30660
Page 12: ......
