Replacing the Fuel Filter
Service Interval:
Every 400 hours
Important:
Replace the fuel filter canister
periodically to prevent wear of the fuel injection
pump plunger or the injection nozzle, due to dirt
in the fuel.
1.
Place a clean container under the fuel filter
canister (
2.
Clean the area where the filter canister mounts.
g018028
Figure 47
1.
Fuel filter
3.
Remove the filter canister and clean the
mounting surface.
4.
Lubricate the gasket on the filter canister with
clean oil.
5.
Install the new filter canister by hand until the
gasket contacts mounting surface.
6.
Bleed the fuel system; refer to
.
Electrical System
Maintenance
Electrical System Safety
•
Disconnect the battery before repairing the
machine. Disconnect the negative terminal first
and the positive last. Connect the positive terminal
first and the negative last.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.
Checking the Electrical
System
Service Interval:
Every 500 hours
Inspect all electrical connections and cables and
replace any which are damaged or corroded. Spray a
good quality water inhibitor onto exposed connections
to prevent moisture ingress.
Checking the Battery
Condition
Service Interval:
Every 250 hours
Note:
When removing the battery, always disconnect
the negative (-) cable first.
Note:
When installing the battery, always connect
the negative (-) cable last.
Raise the engine cover. Remove any corrosion from
the battery terminals using a wire brush and apply
petroleum jelly to the terminals to prevent further
corrosion. Clean the battery compartment.
Under normal operating conditions the battery will
not require any further attention. If the machine has
been subject to continuous use under high ambient
temperature conditions, the battery electrolyte may
require topping up.
Remove the cell covers and top up with distilled water
to a height 15 mm below the top of the battery. Install
the cell covers.
Note:
Check the condition of the battery cables.
Install new cables when current ones are showing
signs of wear or damage and tighten any loose
connections as necessary.
41
Summary of Contents for 30654
Page 36: ...Service Interval Chart g025069 Figure 40 36 ...
Page 57: ...Notes ...
Page 58: ...Notes ...
