Toro 30609, Operator'S Manual

Page: 30 / 84

1. Park the machine on a level surface.
2. Start the engine and raise the mower decks to
change height of cut.
3. Shut off the engine, engage the parking brake,
and remove the key from the ignition after the
mower deck is raised.
4. Position the caster-wheel axles in the same
holes in all caster forks.
g008866
Figure 22
1. Tensioning cap 4. Top axle-mounting hole
2. Spacers 5. Caster wheel
3. Shims
Note:
When operating in 64 mm (2-1/2 inch)
height of cut or higher, install the axle bolt in the
lower caster-fork hole to prevent grass buildup
between the wheel and the fork. When operating
at heights of cuts lower than 64 mm (2-1/2
inches) and grass buildup is detected, reverse
the machines direction to pull any clippings
away from the wheel/fork area.
5. Remove the tensioning cap from the spindle
shaft and slide the spindle out of the caster arm
(
Figure 22 ).
6. Install 2 shims onto the spindle shaft as they
were originally installed.
Note:
These shims require a level across the
entire width of the mower decks. Slide the
appropriate number of 13 mm (1/2 inch) spacers
(refer to the chart below) onto the spindle shaft
to attain the desired height of cut; then slide the
washer onto the shaft.
Refer to the following chart to determine the
combinations of spacers for the setting (
Figure
23 ):
decal100-5622nc
Figure 23
7. Push the caster spindle through the front caster
arm and install the shims (as they were originally
installed) and the remaining spacers onto the
spindle shaft.
8. Install the tensioning cap to secure the assembly.
9. Remove the hairpin cotter and clevis pin
securing the height-of-cut chains to the rear of
the mower deck (
Figure 24 ).
g011596
Figure 24
1. Height-of-cut chain 2. Clevis pin and hairpin
cotter
10. Mount the height-of-cut chains to the desired
height-of-cut hole with the clevis pin and hairpin
cotter (
Figure 25 ).
decal100-5624nc
Figure 25
30