Figure 55
1.
Cam
4.
Turnbuckle
2.
Nut and bolt
5.
Switch screws
3.
Wing nut
9. After the cam is adjusted, the lever switch needs to
be checked.
10. Check the gap between the control lever and switch
as shown in Figure 56. The gap needs to be between
a 1/16 inch to 3/32 inch (1.6 mm to 2.4 mm).
11. If needed, loosen the screws holding the switch and
adjust the switch.
12. Tighten the screws and install the cover under the
control panel.
Figure 56
1.
Right side motion control
lever pivot shown under
controls
3.
1/16 inch to 3/32 inch
(1.6 mm to 2.4 mm) gap
needed between switch
and control lever
2.
Right side motion control
lever
4.
Switch
Adjusting the Neutral Postion for the
Motion Control Levers
Important:
Ensure the tracking of the mower is
correct after adjusting the motion control levers.
After adjusting the tracking, the motion control
levers may not align the exactly front to back
(Figure 57).
If the motion control levers do not align front to back,
or the right side control lever does not move easily into
the neutral lock position, adjustment is required. Adjust
each lever and control rod separately.
Note:
Adjust the horizontal alignment before the front
to back alignment.
1. After the horizontal alignment is finished, check the
front to back alignment (Figure 57).
41
Summary of Contents for 30484
Page 56: ...Schematics Hydraulic Schematic Rev A 56...
Page 57: ...Electrical Schematic Rev A 57...
Page 58: ...Notes 58...
Page 59: ...Notes 59...
