17
5
Step
Parts needed for this step:
•
2 Hairpin cotter pins
Installing the Hairpin Cotter
Pins and Washers
Unused height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On the opposite side of the muffler, install unused
washers and hairpin cotter pins into front and rear
height–of–cut pins (Fig. 10).
m-6505
3
2
1
Figure 10
1.
Hairpin cotter
2.
Unused spacers
3.
Height–of–cut post
6
Step
No parts needed for this step.
Checking the Tire Pressure
Refer to Page 30 for the correct correct tire pressure.
7
Step
Parts needed for this step:
•
1 Rear weight
•
2 Capscrews
•
2 Washers
•
2 Nuts
Installing the Mid Size Weight
1. Remove lag screws securing weight to the shipping
crate. Remove the weight and discard the screws.
2. Secure the weight to rear of the frame with
2 capscrews, washers and nuts (Fig. 23).
Note: The weight mounted in the rear position is
recommended, except when a Tru–Trak
Sulky is
installed.
1
3
2
4
Figure 11
1.
Weight
2.
Capscrew
3.
Washer
4.
Nut
With the weight installed in the rear position, the
front end of the machine can rapidly raise up when
the mower is removed. This could cause serious
injury to you or bystanders.
•
Support the rear of the machine when removing
the mower from the carrier frame.
Warning
Summary of Contents for 30432
Page 6: ...6...
Page 7: ...7 Slope Chart...
Page 8: ...8...
Page 10: ...10 104 8186 104 8569 105 4111 105 4146 106 5532 106 0699 106 5511 106 0635...