8
Re-installing the Panels
Parts needed for this procedure:
2
Corner mat (supplied with cab model 30371)
2
Seal
Procedure
1. Place the rear panel into position and align the top
mounting holes with the holes in the frame cross
member (Figure 59). Secure the top of the panel to
the cross member with 3 screws previously removed.
Figure 59
1.
Rear panel
2.
Screws (3)
2. Align the corner mat mounting holes with the
bottom holes in the rear panel and the lower frame
cross member holes (Figure 60). Secure the corner
mats to the rear panel and cross member with 2 rear
panel mounting screws previously removed. Use the
remaining screw to secure the bottom middle of the
rear panel to the cross member.
Figure 60
1.
Seal (2)
3.
Rear panel
2.
Corner mat (2)
3. Clean the right and left edges of the rear panel. Make
sure all grease and/or oil is removed from the panel
to assure proper adhesion.
4. Remove the backing and affix the self-adhesive seals
to each edge of the rear panel (Figure 60). Make sure
each seal butts up against the fuel tank side panels.
5. Install the floor plate cover (Figure 61) and the front
cover (Figure 62).
Figure 61
1.
Floor plate cover
2.
Mounting screws
24
