Figure 56
7
Installing the Cab Mount
Supports
Parts needed for this procedure:
2
Cab mount support (supplied with cab model 30371)
2
Bolt (1/2 x 3–1/2 inches) (supplied with cab model
30371)
2
Nut (1/2 inch) (supplied with cab model 30371)
2
Bolt (3/4 x 3–1/2 inches) (supplied with cab model
30371)
2
Lockwasher (3/4 inch) (supplied with cab model
30371)
2
Nut (3/4 inch) (supplied with cab model 30371)
Procedure
1. Remove the bolt, nut, hair pin cotter and pin securing
each ROPS assembly to the ROPS posts (Figure 57).
Remove the ROPS assembly.
Figure 57
1.
ROPS
4.
Bolt & nut
2.
Pin
5.
ROPS post
3.
Cotter pin
2. Loosely install a cab mount support to each ROPS
post with two bolts (1/2 x 3–1/2 inches), two nuts
(1/2 inch), two bolts (3/4 x 3–1/2 inch) and two
nuts (3/4 inch) (Figure 58). Make sure the top plate
hole is positioned forward. Do not tighten bolts at
this time.
Figure 58
1.
ROPS post
3.
Top plate hole
2.
Cab mount support
23
