Figure 13
1. Carrier Frame
4. Spacers
2. Hairpin Cotter
5. Front height-of-cut post
3. Back height-of-cut post
Adjusting the Anti-Scalp
Rollers
The anti-scalp rollers need to be adjusted in
the proper hole location for each height-of-cut
position. There needs to be 3/8 inch (10 mm)
minimum clearance above the ground.
Note:
If the anit-scalp rollers are adjusted too
low it can cause excess wear of the rollers.
1. After adjusting height-of-cut, check the
anti-scalp rollers so that there is a minimum of
3/8 inch (10 mm) clearance above the ground
(Figure 14, Figure 15).
2. If adjustment is needed, remove the bolt,
washers and nut (Figure 14, Figure 15).
3. Select a hole position so the anti-scalp rollers
are a minimum of 3/8 inch (10 mm) off the
ground (Figure 14, Figure 15).
4. Install the bolt and nut (Figure 14, Figure 15).
Figure 14
1. Mower deck
4. Anti-Scalp Rollers
2. Bolt
5. Nut
3. Spacer
Figure 15
1. Mower deck
4. Bushing
2. Bolt
5. Anti-Scalp Rollers
3. Spacer
6. Nut
5. In certain mowing conditions and terrain,
a mismatch of cutting height may be seen.
Adjusting the outside anti-scalp rollers to the
minimum setting of 3/8 inch (10 mm) will help
prevent the mower deck cutting too low on the
outside and minimize the mismatch.
Adjusting the Handle Height
The handle position can be adjusted to match the
operator’s height preference.
21
