3. Repeat this for the remaining slots.
4. Check each slot again and make slight adjustments
until the feeler gauge between the rotor and armature
with very slight contact between them.
Figure 44
1.
Adjusting nut
3.
Feeler gauge
2.
Slot
Cooling System
Maintenance
Cleaning the Air Intake Screen
Service Interval:
Before each use or daily
Remove any build-up of grass, dirt or other debris from
the cylinder and cylinder head cooling fins, air intake
screen on flywheel end, and carburetor-governor levers
and linkage. This will help insure adequate cooling and
correct engine speed and will reduce the possibility of
overheating and mechanical damage to the engine.
33
Summary of Contents for 30094
