Toro 30072, Operator'S Manual, Page: 10 / 44

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
Handle assembly 1 Install the handle assembly.
2
No parts required
–
Check and adjust the shift lever plate.
Operator’s Manual 1
Engine Operator’s Manual 1
Training material 1
3
Registration Card 1
Read the Operator’s Manual and watch
the training material before operating
the machine.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Installing the Handle Assembly
Parts needed for this procedure:
1 Handle assembly
Procedure
1. Loosen the upper mounting bolts to allow the handle
to pivot (Figure 4).
2. Remove the lower mounting bolts.
3. Position the handle at the middle hole and install the
lower mounting bolts (Figure 4).
4. Tighten all four of the mounting bolts (Figure 4).
Note:
The controls are setup for the handle height
in the middle hole. If a different handle position is
desired, the controls will need to be adjusted.
G015466
9
Figure 4
1. Upper handle 6. Lower mounting holes
2. Rear frame 7. Low position
3. Flange nut, (3/8 inch) 8. High position
4. Flange bolt, (3/8 x 1 inch) 9. Correct hole to use for
initial setup of handle
5. Upper mounting hole
2
Checking and Adjusting the
Shift Lever Plate
No Parts Required
Procedure
1. Shift lever to second gear and check alignment
of lever in slot of shift lever plate. The clearance
10