•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately stop the engine, disconnect the wire from
the spark plug, and examine the machine for damage.
•
For best performance, install a new blade before the
cutting season begins.
•
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
•
Cut only about a third of the grass blade at a time. Do not
cut below the 51 mm (2 inch) setting unless the grass is
sparse or it is late fall when grass growth begins to slow
down. Refer to Adjusting the Cutting Height.
•
When cutting grass over 15 cm (6 inches) tall, mow at the
highest cutting height setting and walk slower; then mow
again at a lower setting for the best lawn appearance. If
the grass is too long, the machine may become clogged
and cause the engine to stall.
•
Mow only dry grass or leaves. Wet grass and leaves tend
to clump on the yard and can cause the mower to become
clogged or the engine to stall.
WARNING
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Mow only in dry
conditions.
•
Alternate the mowing direction. This helps disperse the
clippings over the lawn for even fertilization.
•
If the finished lawn appearance is unsatisfactory, try one
or more of the following:
–
Replace the blade or have it sharpened.
–
Walk at a slower pace while mowing.
–
Raise the cutting height on the machine.
–
Cut the grass more frequently.
–
Overlap cutting swaths instead of cutting a full swath
with each pass.
–
Set the cutting height on the front wheels one notch
lower than the rear wheels. For example, set the front
wheels at 51 mm (2 inches) and the rear wheels at 64
mm (2-1/2 inches).
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn shows
through the cut leaf cover. You may need to make more
than one pass over the leaves.
•
If there are more than 13 cm (5 inches) of leaves on the
lawn, set the front cutting height one or two notches
higher than the rear cutting height.
•
Slow down your mowing speed if the machine does not
cut the leaves finely enough.
11
Summary of Contents for 29643
Page 18: ...Notes 18...
