SmartTouch™ Home
Screen
SmartTouch mode allows the operator to load and
unload pipes from the rod box with less joystick
operation to reduce operator fatigue.
Use the
Carriage Settings Screen (page 14)
to turn
SmartTouch mode on and off.
Note:
The Push/Pull Icons have a green background
when SmartTouch mode is on and a ribbon appears
at the bottom of the screen showing a sequence of
the steps.
Important:
Never switch between Push/Pull
modes during the chosen operation. Use neutral
(manual) mode to switch between Push/Pull; refer
to
Carriage Settings Screen (page 14)
to turn
SmartTouch mode off.
The SmartTouch screens appears along the bottom of
the home screen as shown below.
g231722
Figure 9
Pulling Pipe in SmartTouch Mode
Start the SmartTouch mode with the cam assembly in
the home position (row 4 of the pipe box).
g236957
Figure 10
1.
Go to the previous step
2.
Go to the next step
Important:
Push and hold the lower section of
the cam rocker switch on the left joystick until the
action is complete in each step (
g210060
Figure 11
Push and hold the upper section of the cam
rocker switch on the left joystick until all actions
are complete to go to the previous step in the
sequence (
).
g210061
Figure 12
5