Toro 22in Recyler, Manual

Page: 6 / 60

Setup
Important:
Remove and discard the protective plastic
sheet that covers the engine.
1
Installing the Handle
No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the machine housing
(
Figure 3 ).
Important:
Route the cables to the outside of the
handle knobs as you install the handle.
G017283
Figure 3
2. Move the handle to the operating position.
3. Install and tighten the handle knobs that you removed
in step
1 ( Figure 3 ).
2
Filling the Engine with Oil
No Parts Required
Procedure
Your machine does not come with oil in the engine.
1. Remove the dipstick ( Figure 4 ).
Figure 4
2. Slowly pour oil into the oil-fill tube until the oil level
reaches the Full line on the dipstick ( Figure 4 ). Do not
overfill. (Max. fill: 0.65 L (22 oz), type: 10W-30 or
SAE 30 detergent oil with an API service classification
of SJ or higher.)
Note:
Each time you check the oil level, remove the
dipstick and wipe it clean, insert it into the oil filler
neck (but
do not screw it in), then remove it again and
check the level ( Figure 4 ).
Note:
If you overfill the engine, pour some oil out of
it; refer to Changing the Engine Oil (page 13) .
3. Install the dipstick securely.
Important:
Change the engine oil after the first 5
operating hours; change it yearly thereafter. Refer
to
Changing the Engine Oil (page 13) .
4