Toro 22in Recyler, Manual

Page: 15 / 60

WARNING
Tipping the machine may cause the fuel to
leak. Fuel is flammable, explosive and can
cause personal injury.
Run the engine dry or remove the fuel with a
hand pump; never siphon.
Servicing the Air Cleaner
Service Interval: Every 25 hours/Yearly (whichever comes
first)—Check the air cleaner for dirty,
loose, or damaged parts, and clean or
replace them if necessary.
Every 100 hours/Yearly (whichever comes
first)—Replace the air-cleaner element (more
frequently when operating the machine in dusty or
dirty operating conditions).
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance (page 12) .
2. Unscrew and open the air-cleaner cover ( Figure 16 ).
G014713
1
2
3
Figure 16
1. Screw 3. Air-cleaner element
2. Air-cleaner cover
3. Replace the air-cleaner element.
4. Install the air-cleaner cover.
Changing the Engine Oil
Service Interval: After the first 5 hours
Every 50 hours/Yearly (whichever comes first)
Run the engine a few minutes before changing the oil to warm
it. Warm oil flows better and carries more contaminants.
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance (page 12) .
2. Remove the dipstick ( Figure 17 ).
Figure 17
3. Tip the machine onto its side, with the air filter up, then
remove the dipstick to drain the used oil out through
the oil-fill tube (
Figure 18 ).
G017322
Figure 18
4. Slowly pour oil into the oil-fill tube until the oil level
reaches the Full line on the dipstick ( Figure 17 ). Do
not overfill. (Max. fill: 0.65 L (22 oz), type: 10W-30 or
SAE 30 detergent oil with an API service classification
of SJ or higher.)
Note:
Each time you check the oil level, remove the
dipstick and wipe it clean, insert it into the oil filler
neck (but
do not screw it in), then remove it again and
check the level of the dipstick.
Note:
If you overfill the engine, pour some oil out
of it.
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
13