Setup
Installing an Accessory to
the Tool Frame
All accessories (scarifier teeth, boom jib, and hitch)
are installed into the slots in the tool frame in the
same way.
g004043
Figure 3
Scarifier tooth installation shown
1.
Tool frame
3.
Clevis pin
2.
Scarifier tooth
4.
Hairpin cotter
1.
Slide the slot on top of the accessory into the top
bar of 1 of the 3 accessory positions (
).
Note:
Install the boom jib and hitch in the
center position. Install the scarifier teeth in any
or all 3 positions (up to 3 teeth may be installed
at a time).
2.
Swing the bottom of the accessory into the
frame and secure it with a clevis pin (
).
3.
Secure the pin with a hairpin cotter (
).
4.
Repeat steps
through
for the remaining
accessory positions, if needed.
5.
If you are installing the hitch, purchase and
install a ball hitch that is appropriate for your
trailer application.
Note:
The hole in the hitch accepts a ball hitch
with a 2.5 cm (1 inch) diameter stud.
Product Overview
g004060
Figure 4
1.
Tool frame
3.
Hitch
2.
Scarifier/ripper tooth
4.
Boom jib
5
