Figure 27
1.
Hand knob
2. Tilt the rear access cover down and remove to access
the internal components (Figure 27).
Closing the Rear Access
Cover
1. Move the rear access cover in place over the back
of the traction unit making sure the tabs line up in
the slots.
2. Push the access cover forward, lining up the hand
knob screws with the threaded holes in the machine.
3. Screw the hand knobs tight to secure the rear access
cover in place.
Removing the Side Screens
1. Open the hood.
2. Slide the side screens (Figure 28) up and out of the
slots in the front screen and frame.
Figure 28
1.
Side screen
Installing the Side Screens
Slide the side screens into place in the slots in the front
screen and frame.
Removing the Front Screen
If the engine has been running the heat shield
will be very hot and could burn you.
Allow the traction unit cool completely before
touching the heat shield.
1. Open the hood and remove both side screens.
2. Loosen the bolts securing the front weight
(Figure 29).
Figure 29
1.
Front weight
3.
Heat shield
2.
Bolts
4.
Carriage bolts
3. Remove the carriage bolts and nuts securing the heat
shield (Figure 29).
4. Lift the heat shield up and off of the traction unit.
5. Remove the 4 bolts securing the front screen to the
traction unit frame (Figure 30).
27
Summary of Contents for 22331 TX 420
